Well, the board is either fixed, or it's going to run terribly. Cross your fingers and hope for the best. I'm at my technical limit right now.

Search found 6 matches

by czgunner
Sun Feb 16, 2020 11:06 pm
Forum: Gunsmithing
Topic: Need a riser (solved)
Replies: 6
Views: 1499
United States of America

Re: Need a riser

JaxxyFur wrote:
czgunner wrote:
Sun Feb 16, 2020 10:53 pm
I’ve got a nice YHM riser that I’m not using if you are interested.
yeah that would be great. what can you tell me about it? what kind of model is it and what are you wanting for it? :)
Sent you a pm
by czgunner
Sun Feb 16, 2020 10:53 pm
Forum: Gunsmithing
Topic: Need a riser (solved)
Replies: 6
Views: 1499
United States of America

Re: Need a riser

I’ve got a nice YHM riser that I’m not using if you are interested.
by czgunner
Fri Jan 11, 2019 12:05 am
Forum: M1 Garand
Topic: HARD to lock clips in
Replies: 7
Views: 3277
United States of America

Re: HARD to lock clips in

Is it hard to push the clip down the last half inch till it locks down and releases the bolt or the whole way? If you're not use to it, it can seem extreme. Tried another type of clip(aftermarket, U.S. or foreign military)? Ammo seated all the way to back of clip? Heavy new finish on clips and/or r...
by czgunner
Thu Jan 10, 2019 9:25 pm
Forum: M1 Garand
Topic: HARD to lock clips in
Replies: 7
Views: 3277
United States of America

Re: HARD to lock clips in

Ghoulardi wrote:my advice, disassemble it then reassemble it, then try it again
Done that 5 times looking for problems.
by czgunner
Thu Jan 10, 2019 8:51 pm
Forum: M1 Garand
Topic: HARD to lock clips in
Replies: 7
Views: 3277
United States of America

HARD to lock clips in

I have a new CMP special. Probably 200 rounds through it.
It is nearly impossible to lock a clip in. It takes an absurd amount of struggling.
I contacted CMP, but I am out of warranty.
Didn’t get to shoot it the first year, as I have been a busy dad.
Any help would be appreciated.
by czgunner
Thu Aug 31, 2017 4:46 pm
Forum: Reloading
Topic: M1 garand reloading
Replies: 7
Views: 4963
United States of America

M1 garand reloading

I'm getting set to start loading for my CMP "special". I have all the equipment as I have been loading for a few years. I have the RCBS rockchucker. A set of Forster dies is coming in the mail. How is the best way to determine shoulder bump for the garand? Should I not worry about it? I just full le...

Go to advanced search