Page 1 of 1

M1/M14 marring other riflestocks in your gunsafe?

Posted: Sun Jun 04, 2017 3:35 pm
by Youngblood
M1/M14 Variant marring other riflestocks in your gunsafe?

Image

:)

Re: M1/M14 marring other riflestocks in your gunsafe?

Posted: Sun Jun 04, 2017 6:52 pm
by fordmech00
You sir are a genius 😀

Re: M1/M14 marring other riflestocks in your gunsafe?

Posted: Sun Jun 04, 2017 7:08 pm
by Youngblood
:) Thanks.

BTW, those items are cut from thick vinyl tubing that can be purchased by the foot at Lowes (and probably other places).

1"OD x 3/4"ID & 1/2"OD x 3/8"ID

Enjoy!

Re: M1/M14 marring other riflestocks in your gunsafe?

Posted: Sun Jun 04, 2017 7:25 pm
by DeaconKC
That is a great idea

Re: M1/M14 marring other riflestocks in your gunsafe?

Posted: Mon Jun 05, 2017 12:02 pm
by DaleH
I have a plastic sight protector that slip over the rear & front sights (M1) and have been placing a yellow "thread protector" rubber cap on the op handle. Any hardware store carries them. Some places sell them as 'vacuum caps' to protect oil/gas line fitting ends.

Re: M1/M14 marring other riflestocks in your gunsafe?

Posted: Tue Jun 06, 2017 1:20 am
by jones0430
I just use a rifle sock.

Re: M1/M14 marring other riflestocks in your gunsafe?

Posted: Tue Jun 20, 2017 10:48 am
by timbo1955
been using automotive vacuum caps on the M1 and M1A , FN49"s , of course after I scratched and dented the works

Re: M1/M14 marring other riflestocks in your gunsafe?

Posted: Fri Jun 30, 2017 8:25 pm
by bobvz
I alternate my rifles muzzle up muzzle down. This prevents mishaps like that. It also allows you to get more guns in your safe.

Re: M1/M14 marring other riflestocks in your gunsafe?

Posted: Thu Oct 19, 2017 7:16 am
by timbo1955
Automotive caps and a canvas cover