Well, the board is either fixed, or it's going to run terribly. Cross your fingers and hope for the best. I'm at my technical limit right now.

Mauser Trigger & Sear Pins

Post Reply
User avatar
Posts: 256
Joined: Sat Jun 03, 2017 10:27 pm
Age: 40
Location: Southeast US
United States of America

Mauser Trigger & Sear Pins

#1 Post by Zeliard » Sat Jul 29, 2017 9:21 pm

Originally posted by Jeff S.

I've seen a lot of battered, broken and bent trigger and sear pins for '93, 94, 95, 96, 98 Mausers including the German, Swedes, Turks, Czechs, Persians, South Americans, Spanish, and Polish. Instead of going to a gun supply and paying $5 or so plus shipping for one used pin, head down to an industrial hardware store. In Southern California, McFaddendale Hardware stores are everywhere - or go to McMaster Carr online. For about the same as you'd pay a gun parts dealer, you can get a pack of 100 dowel pins. The size is 3mm dia x 12 mm long and the hardened steel pins are the correct replacements and will fit both the trigger and sear pin locations. The McMaster Carr part no is 91595A112 and they have a web site here: http://www.mcmaster.com/
Proud alumni of Transylvanian Polygnostic University. "Know enough to be afraid."

"Vertroue in God en die Mauser".-Faith in God and the Mauser.

"Send lawyers, guns and money." -Warren Zevon

Post Reply

Return to “General Gunsmithing”

Who is online

Users browsing this forum: No registered users and 2 guests