Well, the board is either fixed, or it's going to run terribly. Cross your fingers and hope for the best. I'm at my technical limit right now.

Enfield No.2 Mk1

Post Reply
Message
Author
User avatar
vandle
Bullet Banger
Bullet Banger
Posts: 603
Joined: Sun Jun 04, 2017 6:08 pm
Age: 51
Location: Brisbane Australia
Australia

Enfield No.2 Mk1

#1 Post by vandle » Mon Apr 30, 2018 8:49 pm

Hi all

I'm looking for the holy grail.

Is there a company in the states who has the firing pin for the Enfield No.2Mk1.

I have checked Numerich but they are out of stock.
Any help will be appreciated. :pray:

Cheers
Life is tough, tougher if your stupid

User avatar
lloydiam
Member
Member
Posts: 88
Joined: Wed Apr 04, 2018 11:09 am
Age: 62
Location: Brookfield
United States of America

Re: Enfield No.2 Mk1

#2 Post by lloydiam » Mon Apr 30, 2018 9:21 pm

Hammer nose for that pistol should NOT be that hard to build !...........

User avatar
vandle
Bullet Banger
Bullet Banger
Posts: 603
Joined: Sun Jun 04, 2017 6:08 pm
Age: 51
Location: Brisbane Australia
Australia

Re: Enfield No.2 Mk1

#3 Post by vandle » Mon Apr 30, 2018 11:07 pm

lloydiam wrote:
Mon Apr 30, 2018 9:21 pm
Hammer nose for that pistol should NOT be that hard to build !...........
That is my other option and maybe my only one......
Life is tough, tougher if your stupid

User avatar
RWS
Global Moderator
Global Moderator
Posts: 267
Joined: Sat Jun 03, 2017 7:26 am
Age: 66
Location: Nashville, Tennessee
United States of America

Re: Enfield No.2 Mk1

#4 Post by RWS » Tue May 01, 2018 8:35 am

You might at least get the firing pin rivet from Numrich (part #30) since they have it in stock for $3.15. My luck would be to find a firing pin but no rivet.

Also, my guess is that it may be easier to find a used hammer with a firing pin on it and rob the pin to put on yours, unless by dumb luck the hammer you find actually fits and functions on your frame. However, if you have to remove the firing pin from a donor hammer you will wish you had a new firing pin rivet.

- Bob

SWIHARTMARK
Member
Member
Posts: 289
Joined: Mon Jun 05, 2017 5:09 pm
Age: 54
Location: DAYTON, OHIO
United States of America

Re: Enfield No.2 Mk1

#5 Post by SWIHARTMARK » Sat Jan 19, 2019 6:58 pm

Ummh, just came across this. Jack First has you part as I broke mine and got one there. They are out of the Dakotas. You should be able to google them up. If they don't have it in stock, they make them. A bit pricey, but a life saver. I attaches to the hammer, correct.

Best Regards,

Mark

Post Reply

Return to “British Empire and Commonwealth Pistols”

Who is online

Users browsing this forum: No registered users and 1 guest